Number of nozzle
intensity of pressure
chilled water( apolegamy)
intensity of pressure
Diameter Of Rctary Tabel
Power of electricity heater,
Power of fan
power of rotary table motor
Inlet air temperatre
Δt=140℃ ，automatic adjustment
material yielding rate
drying product moisture
5‰-5%，Depending on the humidity of the medium.
The fan isolation process is less than 75 db.
According to the plan
Material upward movement in the air thrust from the hopper to the diffusion chamber, as a result of the diffusion chamber diameter is larger, the air flow rate is low, after the material of its own gravity to overcome the airflow thrust whereabouts, reciprocating fluidized state formation.
But fluidization is irregular and is not strictly controlled.
This is different from the base spray and tangential spray.
The liquid medium is transported to the system through the atomization system, and the nozzle is atomized into a very small droplet that is injected into the system, and the direction is opposite to the direction of the material movement.
The liquid bridge is built by the surface tension of the liquid medium, and the powder materials are bonded together to form a constant volume and eventually form a certain size particle.
Bottom spray process:
In order to control the movement of the material, an orderly flow state is formed by adding a diaphragm in the hopper and a sieve plate with different opening rates.
The spray is added to the system by the pneumatic nozzle installed in the center of the sieve plate. The nozzle is upward and the upward flow is the same as the direction of the material movement.
There is a certain distance between the diaphragm and the sieve plate to ensure that the material can flow smoothly from the outer ring to the inner circle to form a circular flowing state.
In bottom spray device, particle fluidization state very rules, the particles after injection liquid fog a regular time interval, coating liquid spray near the nozzle orderly movement of the surface of the particles and liquid fog spreading is very uniform, formation of garment film thickness uniformity, no pore, and not, as in top gush, poor performance caused by movement disorder garment membrane.