Reduce production processes and increase product purity

- Jul 26, 2018-

The drying speed is fast, the surface area of the liquid is greatly increased after atomization, and in the hot air flow, 95%-98% of the water can be evaporated instantaneously, and the drying time is only a few seconds, which is especially suitable for drying the heat sensitive material.

The product has good uniformity, fluidity and solubility, and the product has high purity and good quality. The production process is simplified and the operation control is convenient. For liquids with a moisture content of 40-60% (up to 90% of special materials), it can be dried into a powder product at one time. After drying, no pulverization and screening are required, which reduces the production process and improves the purity of the product. The particle size, bulk density and moisture of the product can be adjusted within a certain range by changing the operating conditions, and the control and management are very convenient.

The material to be sprayed needs to be thoroughly emulsified and homogenized by a homogenizer and passed through an 80 mesh screen (to avoid clogging the atomizer and piping), and placed in a stainless steel bucket for use. In addition, a bucket of tap water is used to clean the atomizer and the spray chamber. Install the material of the peristaltic pump, clamp it, and fasten the nut at the front of the feed port with 8 nuts (to prevent it from floating in the air), and put it into the bucket for use.

Check that the butterfly valves on the pipes connected to the dehumidifier and the collecting tank are all open. The damper on the spray tower should be fully open. The spray doors should be closed. The quick-fit clamps of the connecting pipes should be installed correctly. The outlet valve of the compressor should be opened, the vent valve should be closed, and the air pressure pipe should be connected well.

1. The tower body has a cold air jacket;

2. The tower body is equipped with an automatic rapping device;

3. The tower body and pipeline are equipped with quick opening cleaning holes and drain holes;

4, can be equipped with automatic control constant temperature feeding tank;

5, can be equipped with manual high-pressure washing tower random accessories;

6. The part in contact with the material is made of stainless steel; (or made of all stainless steel)

7. The material collection adopts a two-pole cyclone dust removal device, or a first-stage cyclone dust collector and a wet dust collector;

8. The inlet air temperature is automatically controlled and continuous.

9, can be equipped with air sweeping device