Operation Flow Of Capsule Machine

- Dec 24, 2019-

Operation Flow Of Capsule Machine


Capsule filling machine integrates machine, electricity and gas. It adopts micro-computer programmable controller, touch panel operation, frequency conversion speed regulation, equipped with electronic automatic counting device, which can automatically complete the capsule positioning, separation, filling, locking and other actions, reduce labor intensity, improve production efficiency, and meet the requirements of pharmaceutical hygiene. The operation steps of the device are as follows:


1. Press the green button in the "power switch" to connect the power supply.Slowly adjust the "vibration intensity adjusting knob" and rotate clockwise. At this time, the compact disc combined with the "vibration bracket" begins to vibrate. Touch the compact disc by hand and adjust it to a certain vibration intensity by feeling.


2. Put the powder-filled capsule shell into the "powder-filled capsule shell finishing plate", about 300 capsules at a time. Put the capsule cap into the "capsule cap finishing plate", about 300 capsules at a time. The finishing plate is made of plexiglass plate. There are many large and small funnel-shaped round holes drilled on it. The diameter of the round holes corresponds to the diameter of the capsule number. At this time, the capsule shell of the shaking table plate moves steadily and slowly before and after, thus entering the hole of the table plate one by one.


3. For about 30 seconds, the powder capsule shell and capsule cap fall into the round hole and the opening is upward. If individual openings are facing downward, the capsule cap can be used to gently press the sleeve downward, and the capsule cap can be pulled out.Horizontal hand-held powder-filled capsule shell plate (shown at the end of the figure, randomly prepared, with round holes in the plate), in the whole


4.With a gentle push from the lower part of the tray, the powder-filled capsule shell in the tray will fall down into the circular hole of the splice plate, and then take out the splice plate. In the same way, the capsule cap was taken out with the capsule cap cap connecting plate.


5. Prepare a powder tray with a bottom area of 500 *500 mm and a side height of 10 mm. Inside the powder, place the powder capsule shell joint plate in the powder tray. Then the random organic glass frame cover is placed on the contact plate of powder capsule, and a small pinch of bucket shovel powder is put into the frame. With a scrape at the edge of the frame, the powder can be filled, and the surplus powder can be scraped off.


6. The capsule cap cover cover plate with random matching (shown in the middle of the figure, with round holes on the cover plate) is placed on the capsule cap cover plate, with counterpoint holes, which is easy to place. The cap cover plate of the capsule is reversed, so that the capsule opening is downward, and is set on the powder-loaded capsule shell plate of the powder-loaded capsule. There are also counter-position holes, which are easy to fit.Put the encapsulated plate into the cavity under the "Cap-wearing Forming Plate" and pull the "Pressure Bar" downward with your hand and put it in place. You don't have to pay too much attention to it, because the positioning mechanism controls the height of the downward pressure.  Take out the capsule plate, pour out the capsule and fill it.  The next board can be recycled.