The Fan Is An Important Supporting Device For The Dryer

- Jul 26, 2018-

How can the dryer be used to increase efficiency and reduce losses? Dryer users want to achieve efficient dryer operation and reduce losses as much as possible.

First, pay attention to the use of cooling water. The fans and pumps used in the dryer are large equipment, and the fans are basically running continuously, so the motor used is very prone to heat, and water is used for cooling. But today, with increasingly serious environmental problems, water is also a scarce resource. It is recommended that users recycle the cooling water, which not only reduces losses, but also saves water. Second, pay attention to the overall insulation of the dryer. The drying work is mainly the use of heat energy, so the full use of heat energy has become an important one. Therefore, special attention should be paid to the insulation work of the dryer, and no heat loss can occur in any part. Third, the use of the inverter. The fan is an important supporting device for the dryer, and it is basically continuous operation, and its loss is very large. It is necessary to use the inverter here, and the inverter can be used to control the operation of the fan. In addition, the inverter can be added at the dust removal equipment. Fourth, pay attention to the design of the hot air distributor. If thermal energy wants to contact wet materials, it must pass through the hot air distributor. How to design the hot air distributor is an important task, which directly affects whether the material drying can meet the requirements.

Trouble and Elimination of Dryer 1. The moisture content of the material after drying is greater than the specified value. The elimination method is to control the production capacity of the dryer and increase or decrease the supply of heat. 2. The rolling ring has a swing on the cylinder running. The reason is that the side of the concave joint of the rolling ring is not clamped. The elimination method is to use the pad to keep the rolling ring and the concave joint evenly and properly clamped to prevent overtightening and easy. have an accident. 3. The meshing clearance between the large gear and the pinion is broken. The reason is: a. the tug wear b. the wheel wear c. the pinion wear is eliminated by turning or replacing according to the wear condition, or it can be installed in reverse or in pairs. . 4. The whole body vibration is caused by a. The connection between the tug device and the base is broken. The elimination method is to correct the fastening joint to make it in the correct position; b. The side of the race is worn, and the elimination method is based on the degree of wear and tear. The circle is turned or replaced.